[MCPE-71326] Command Block not updating unless messed with or powered.

Note

Many reports of command blocks not working correctly after switching modes are based on misunderstanding the command block UI. Before concluding that you are experiencing a bug, please read the following statement from [Mojang] Mega_Spud (Jay Wells)'s resolution of ~~MCPE-20304~~:

The information shown at the bottom-right of the UI is in fact part of the 'Previous Output' -
this section shows the state of the block when it last executed a command. If you change the block type options on the left and then run a successful command, you will then see the previous output information in question update.

If you have a video or a world save that shows a command block not working correctly, please attach it to the ticket. A screenshot is not enough to show that the command block is malfunctioning.

Are command block’s settings on the right not supposed to update with the display below previous output. I have had this issue for a while. It affects the state of the command block, too. Only way to fix it is to mess with it and power it until it works.